For your jewelry made of precious metals, the solution remains obviously a size up to a jeweler who will perform the work professionally. This will not cost much and your ring will be well adjusted. But be careful to consider the famous phenomenon of fingers swell (particularly in summer or weight changes). In all cases, if your jewelry is valuable, do not you try a home DIY!
To increase the size of your ring, the jeweler will spread it as much as needed after cutting it and will then add a new piece of metal to fill the gap.
Decreasing a ring’s size works in a similar fashion: The jeweler will cut out a strip from the ring and narrow the band by joining the two ends together.
After the resizing is done, the jeweler will put your ring back together by soldering the band where it was cut.
If your ring not expensive, you can resize it at home.
1.Buy Ring Reducer
This small but very clever accessory is quite suitable for all types of rings.This is a small clip made of silicone, rubber or transparent plastic that can be put behind your ring, inside of the hand and that will hold it in place to prevent it from spinning or slipping . Discrete, the ring reducer has significant properties: water resistance, no overflow, hypoallergenic. This is very useful if you fingers tend to swell a lot, if you want to wear a precious ring for an evening before an resizing or for any costume ring.
2. Sizing Down Your Ring With Silicone
Clean the ring thoroughly. Soak the ring in a solution of hot water and dishwashing soap. Use a soft toothbrush to brush the metal and any stones set on the ring.
- Dry the ring thoroughly before moving on.
- Avoid using cleaners with bleach, acetone or chlorine, as these can damage a ring’s metal band.
Use a coffee stir stick to apply silicone sealant inside the ring. Make sure to use clear silicone, like food grade or aquarium grade silicone. You’ll want the bottom part of the ring to have the thickest application. Unless the ring is very loose on your finger, you should use a small amount of silicone.
Smooth the silicone with the coffee stir stick. As the silicone will be directly against your skin, you’ll want to try to smooth it out as much as possible. Run the stick along the inside of the ring until the silicone smooths out.
- You can use a wet paper towel to clean any silicone that gets on the outside of the ring.
Let the silicone cure. Depending on the type of silicone you use, this can take anywhere from 24 to 48 hours. Resist the temptation to wear your ring during this time, as it will take longer for the silicone to cure and might dislodge it entirely.
- If you need to remove the silicone, you simply need to scratch at it with your fingernail.
For sizing up, because it need to cut the ring and then add material, if you are not professional at it, we don’t recommend do it at home.
We are a participant in the Amazon Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon and affiliated sites.